Rampage L4-135 2.2L (1983)
10.
Fold the single connector back along the convoluted tubing and tie wrap in place using one Tie Wrap, PN 4293893, from package. Trim off
excess length of tie wrap (Figure 4).
11.
Install the second tie wrap from package over the larger diameter convoluted tubing adjacent to the wire guide loop. Trim off excess length of
tie wrap.
12.
Reconnect carburetor wiring to wiring harness and vacuum line to solekicker. Connect vacuum line to solekicker vacuum diaphragm nipple.
FIGURE 1
13.
Carefully reinstall secondary throttle return spring on lever and grooved stud, which is also the solekicker bracket retaining screw (Figure 1).
FIGURE 5
14.
Install throttle stop speed screw and spring from package in threaded boss on main body of carburetor near primary throttle lever (Figure 5).
15.
Open throttle and manually open choke blade fully. Turn throttle stop speed screw clockwise until it just contacts throttle lever.
Turn throttle stop speed screw 1/4 turn clockwise after contacting the throttle lever. This completes throttle stop speed screw adjustment
(Figure 5).
