Rampage L4-135 2.2L (1983)
FIGURE 3
12.
Fold the single connector back along the convoluted tubing and tie wrap in place using one tie wrap from package. Trim off excess length of tie
wrap (Figure 3).
13.
Install the second tie wrap from package over the larger diameter convoluted tubing adjacent to the wire guide loop. Trim off excess length of tie
wrap.
14.
Reconnect carburetor wiring to wiring harness and vacuum line to solekicker.
15.
Carefully reinstall secondary throttle return spring on lever and grooved stud which is also the solekicker bracket retaining screw.
16.
Apply a thin film of Multi-Purpose Grease, PN 4318063, or Hi-Temp Grease, PN 4318064, to surface of solekicker terminal which contacts
throttle lever.
17.
Start engine and allow to fully warm up. Adjust curb idle speed to VECI label specification.
FIGURE 5
18.
Type the following information on the Authorized Modification Label PN 4275086 (Figure 5).
Upper Section
Solekicker Package PN (from parts list) Installed.
Lower Section
Change Authority - TSB 14-07-84. Dealer Code - your dealer code. Date - date this service performed.
Install the Authorized Modification Label next to or near the VECI label.
POLICY:
Reimbursable within the provisions of the warranty
