dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

ESA/EFC Module - Acceleration Sag/Rough Idle|Page 2156 > < ESA/EFC Module - Rough Idle Hesitation & Surge|Page 2151
Page 1
background image

Engine Control Module: All Technical Service Bulletins
ESA/EFC Module - Acceleration Sag/Rough Idle

Models

1983 2.2L Passenger Cars W/Manual Transmission & Rampages & Scamp Trucks W/Manual Transmission & Calif.. Emission System (N-95)

Subject

Sag on Acceleration & Hot Restart Rough Idle

Index

FUEL

Date

March 21, 1983

No.

14-11-83

P-838-C
SYMPTOM/CONDITION

Subject model vehicles built before February 21, 1983 (MDH 02-21-XX) may exhibit the following two driveability conditions:

1.

An acceleration sag following a short closed throttle deceleration.

2.

Rough engine idle immediately following a hot soak restart.

NOTE:

This service procedure only applies to vehicles with ESA/EFC module part numbers 5213834 and 5213838.

PARTS REQUIRED Order Replace.
Market

Trans.

Model Orig.ESA/EFC

ESA/EFC

Calif.

Manual

Truck

5213834

5213856

Federal

Manual

Pass.Car

5213834

5213856

Calif.

Manual

Pass.Car

5213838

5213860

Order separately:

1 - Authorized Modification Label

PN 4275086

REPAIR PROCEDURE

1.

Remove original ESA/EFC module and install appropriate replacement ESA/EFC selected from parts chart above.

2.

Start engine and allow to fully warm up.

3.

Check and reset basic timing if necessary to VECI label specifications.

ESA/EFC Module - Acceleration Sag/Rough Idle|Page 2156 > < ESA/EFC Module - Rough Idle Hesitation & Surge|Page 2151