Rampage L4-135 2.2L (1983)
FIGURE 3-E - 25 WAY I/PANEL TO BODY CONN. (WIRE END)
FIGURE 3-F - (TERMINAL END OF WEDGE CONN.)
8.
Remove the 3-way and 10-way wedge connectors from the 25-way instrument panel-to-body connector. Remove and tape back to main
harness the following wires (Figures 3-E and 3-F):
a.
Dark blue wire from cavity #7 of the 10-way wedge connector.
b.
Light blue with black tracer wire from cavity #23 of the 3-way wedge connector (vehicles equipped with "Low Fuel Warning" only).
FIGURE 3-B
9.
Route the two bare terminals of the overlay harness, PN 4331855, behind the parking brake release cable to the retainer clip located near the
25-way instrument panel-to-body connector (Figure 3-B). Insert the dark blue wire into cavity #7 of 10-way connector and the light blue with
black tracer wire into cavity #23 of 3-way connector.
