Rampage L4-135 2.2L (1983)
4.
Reinstall passenger compartment side of bulkhead connector back into dash opening. Be sure it snaps in place.
5.
Install the fuse block back onto the mounting studs on the side cowl.
6.
Allow the 2-way connector of overlay harness, PN 4304901, to hang down to mate with the body harness overlay (Figure 1-A).
7.
Connect overlay harness, PN 4304901, ground terminal to the instrument panel ground stud (Figure 1-A).
8.
Connect the control module, PN 5226640, to the overlay harness connector. Secure the control module onto the instrument panel wiring
harness with a tie wrap (Figure 1-C). Reinstall engine side bulkhead connector and torque to 40 inch pounds. Also reinstall the clutch
cable or shift cable bracket if removed.
FLOOR PAN TOP VIEW FOR 3/4" WIRE GROMMET HOLE LOCATION RIGHT REAR UNDER BACK SEATFIGURE 5
9.
Lift carpet at right rear corner of floor pan and locate existing grommet (Figure 5). Mark and drill a 3/4" hole for the wiring overlay
harness grommet behind the existing hole in floor pan (Figure 5).
CAUTION:
USE CARE WHEN DRILLING HOLE SO AS TO AVOID CONTACT AND POSSIBLE DAMAGE TO FUEL
LINES OR WIRING LOCATED UNDER FLOOR PAN.
FIGURE 2 - FUEL PUMP OVERLAY HARNESS ROUTING THROUGH BODY
10.
Install and route wire assembly, PN 4331826, for electric fuel pump through inner body to grommet location hole at right rear of vehicle
(Figure 2) using the following procedure:
