Rampage L4-135 2.2L (1983)
FIGURE 1 - Wiring Diagram
4.
Disconnect engine harness to chassis harness 8-way connector.
5.
Extract circuit N8, #18 black/red terminal, from female insulator half of engine 8- way connector. Be sure the terminal is clean and bright (Figure
1).
6.
Snap the extracted circuit N8 from Step 5 into the natural color female single insulator that is supplied with overlay harness and pack grease, PN
4318063, into insulator cavities through wire grip areas until full (Figure 1).
7.
Extract circuit N5, #18 black/light blue terminal, from male insulator half of engine 8-way connector. Be sure terminal is clean and bright (Figure
1).
8.
Snap the extracted circuit N5 from Step 7 into the blue color male single insulator that is supplied with overlay harness and pack grease into
insulator from wire end.
