dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Engine - Poor Driveability Cold/Rough Idle|Page 64 > < Ignition System - Cold Drive Sag On During Acceleration|Page 59
Page 1
background image

Engine Control Module: Customer Interest
Engine - Poor Driveability Cold/Rough Idle

Models

1983 2.2L Rampage & Scamp Trucks With Automatic or Manual Transmission & Federal Low Altitude Emission System Only (Without O2 Feedback)
Subject

Cold Driveability Improvement & Rough Idle Warm

Index

FUEL

Date

July 6, 1983

No..

14-19-83 REVISION A

P2378C
This bulletin supersedes Technical Service Bulletin #14-19-83 and has been revised to reflect corrected carburetor part numbers.

SYMPTOM/CONDITION

Subject model vehicles built before December 2, 1982 may exhibit the following driveability conditions:

^

Rough idle, acceleration sags, and poor performance when engine is cold.

^

Rough idle with engine warmed up.

PARTS REQUIRED

Model

Previous

Revised

Item

Application

Part No.

Part No.

ESA/EFC Module

All

5213691

5213868

Carburetor

Auto. Trans.

4227381

*4300018

Carburetor      

Manual Trans.

4227380

*4300017

1 - Carburetor Flange Gasket

PN 4095975

1 - Authorized Modification Label

PN 4275086

*Revised part numbers.

NOTE:

THIS PROCEDURE ONLY APPLIES TO VEHICLES WITH ESA/EFC MODULE PN 5213691.

INSTALLATION INSTRUCTIONS

1.

Install replacement ESA/EFC module.

2.

Install appropriate carburetor from parts chart above, use new Carburetor Flange Gasket, PN 4095975.

3.

Start engine and allow to fully warm up.

4.

Check and reset basic timing, idle rpm, and hot fast idle per VECI label if necessary.

Engine - Poor Driveability Cold/Rough Idle|Page 64 > < Ignition System - Cold Drive Sag On During Acceleration|Page 59