Rampage L4-135 2.2L (1983)
Power Steering Pump: Service and Repair
Power Steering Pump Removal and Installation
1. Remove power steering pump drive belt adjusting bolt and nut, then remove nut attaching pump end hose bracket, if equipped.
2. Raise and support vehicle, then remove nut attaching pump pressure hose locating bracket to crossmember.
3. Disconnect pressure hose from steering gear and allow fluid to drain into a suitable container.
4. Remove drive belt splash shield, then disconnect both pressure and return hoses at power steering pump. Cap hoses and fitting to prevent entry of
dirt.
5. Remove lower stud nut and pivot bolt from power steering pump, then lower vehicle.
6. Remove drive belt pulley from pump, then move pump rearward to clear mounting bracket, and remove adjusting bracket.
7. Rotate pump so pulley faces rear of vehicle, then lift pump assembly from vehicle.
8. Reverse procedure to install.
