Rampage L4-135 2.2L (1983)
Fig. 2 Steering column coupling & shaft adjustment. Motor Home
Tilt Column Release Pedal Adjustment
1. Loosen pedal assembly locknut at adjustable mounting bracket assembly.
2. Move column adjusting assembly foot pad rearward, toward the driver, 0.040 inch from center line of rear column adjustable mounting bracket
bolt. While holding pedal in this position, tighten nut until column is locked securely.
3. Test operation of column adjusting pedal by depressing and releasing several times. If correctly adjusted, the pedal will return to the approximate
position shown.
Fig. 5 Steering column installation. Rampage & Scamp
RAMPAGE & SCAMP
Removal
1. Disconnect battery ground cable.
2. Disconnect all column wiring connectors.
3. Remove lower roll pin from upper universal joint.