Rampage L4-135 2.2L (1983)
Fig. 9 Lower control arm assembly
INSTALLATION
1. Install retainer, bushing and sleeve on stub strut.
2. Position control arm over sway bar and install rear stub strut and front pivot into crossmember.
3. Install front pivot bolt and loosely assemble nut.
4. Install stub strut bushing and retainer and loosely assemble nut.
5. Install ball joint stud into steering knuckle, then the clamp bolt. Torque clamp bolt to 50 ft. lbs. (67 N-m) for 1982 - 83 models, 70 ft. lbs. (95
N-m) for 1984 models.
6. Place sway bar end bushing retainer to control arm, then install retainer bolts. Torque retainer bolts to 22 ft.lbs. (30 N-m) for 1982 - 83 models, 25
ft. lbs. (34 N-m) for 1984 models.
7. Lower vehicle so suspension fully supports vehicle, then torque front pivot bolt to 105 ft. lbs. (142 N-m) and stub strut nut to 70 ft. lbs. (95 N-m).
