Rampage L4-135 2.2L (1983)
procedures may be applied to all.
Fig. 5 Removing bearings from yoke using a small socket as a driver & large socket as a receiver
WITHOUT UNIVERSAL JOINT REPLACEMENT TOOL
DISASSEMBLY
1. Remove snap rings (or retainer plates) that retain bearings in yoke and drive shaft.
2. Place U-joint in a vise.
3. Select a wrench socket with an outside diameter slightly smaller than the U-joint bearings. Select another wrench socket with an inside
diameter slightly larger than the U-joint bearings.
4. Place the sockets at opposite bearings in the yoke so that the smaller socket becomes a bearing pusher and the larger socket becomes a
bearing receiver when the vise jaws come together. Close vise jaws until both bearings are free of yoke and remove bearings from the
cross or spider.
5. If bearings will not come all the way out, close vise until bearing in receiver socket protrudes from yoke as much as possible without using
excessive force. Then remove from vise and place that portion of bearing which protrudes from yoke between vise jaws. Tighten vise to
hold bearing and drive yoke off with a soft hammer.
6. To remove opposite bearing from yoke, replace in vise with pusher socket on exposed cross journal with receiver socket over bearing cup.
Then tighten vise jaws to press bearing back through yoke into receiving socket.
7. Remove yoke from drive shaft and again place protruding portion of bearing between vise jaws. Then tighten vise to hold bearing while
driving yoke off bearing with soft hammer.
8. Turn spider or cross 1/4 turn and use the same procedure to press bearings out of drive shaft.
