Spirit R/T L4-135 2.2L DOHC Turbo (1991)
Belt Tension Gauge Location
10. Adjust tension to 445 N (110 lbs.). Install belt tension gauge on timing belt adjust tensioner until specified tension is achieved.
CAUTION: Belt tension gauge must be installed between the belt teeth to get a accurate reading.
11. Rotate crankshaft clockwise 2 full revolutions and check alignment of camshaft and crankshaft timing marks. Do not reverse rotate crankshaft or
attempt to rotate engine using cam or accessory shaft attaching screw.
CAUTION: Do not allow oil or solytents to contact the timing belt as they can deteriorate the rubber and cause tooth skipping.
12. Recheck belt tension, adjust if necessary.
Rocker Arm Shaft Installation
13. Torque rocker arm shafts in sequence shown to 24 Nm (210 in. lbs.).
14. Install valve covers, spark plugs, ignition cables and ignition cable cover.
15. Install air cleaner fresh air duct.
16. Raise vehicle. Install lower timing belt cover and accessory drive belt tensioner pulley.