Sprinter 2500 L5-2.7L DSL Turbo (2003)
b = 15 mm,
c = 11 mm.
2. Drill all marked holes with 6 mm dia. bit.
3. Grind waist rail paneling (1) down to bare metal in marked area (6) and coat with zinc dust paint.
4. Fit waist rail paneling, align and clamp.
Welding in waist rail paneling
The following steps apply for the right side of the of waist rail paneling (1) and must be performed on the left side with locations reversed.
1. Weld waist rail paneling (1) to A-pillar inner section (4) (A).
2. Weld waist rail paneling (1) to waist rail brace (3).
3. Align A-pillar paneling (2) and weld to waist rail brace and waist rail paneling (1).
4. Spot weld waist rail paneling (1) to waist rail brace (arrows).
