Sprinter 2500 L5-2.7L DSL Turbo (2003)
Electronic Brake Control Module: Service and Repair
REMOVAL
1. Remove the negative battery cable from the battery.
2. Pull up on the Controller Antilock Brake (CAB) harness connector release and remove connector.
3. Remove the CAB mounting bolts.
4. Remove the CAB from the Hydraulic Control Unit (HCU).
INSTALLATION
1. Install CAB to the HCU.
2. Install mounting bolts. Tighten to 2 Nm (16 in. lbs.).
3. Install the wiring harness connector to the CAB and push down on the release to secure the connector.
4. Install negative battery cable to the battery.
