Sprinter 2500 L5-2.7L DSL Turbo (2003)
Rear A/C Control Module
9. Disconnect the wire harness connectors from the rear A/C control module.
10. Remove the rear A/C control module retainers and the control module from the vehicle.
INSTALLATION
1. Install the rear A/C control module and control module retainers.
2. Connect the wire harness connectors to the rear A/C control module.
3. Install the rear evaporator panel onto the rear evaporator housing and install the three push-pin fasteners.
4. If equipped, connect the wire harness connector to the interior motion sensor and install the sensor into the evaporator panel.
5. Install the five evaporator panel screws at the front of the panel. Tighten the screws to 2 N.m (17 in. lbs.).
6. Install the roof duct panel and the six push-pin fasteners.
7. Connect the dome light wire harness connector and install the dome light into the roof duct panel.
8. Reconnect the battery negative cable.
