Sprinter 2500 L5-2.7L DSL Turbo (2003)
Starter Relay: Service and Repair
REMOVAL
Fuse/Relay Block
The starter relay is located in the Fuse/Relay Block. The Fuse/Relay Block is located under, and to the left side of the drivers seat. See Fuse/Relay Block
cover for relay identification and location.
Fuse/Relay Block Cover
1. Remove Fuse/Relay Block cover by pushing down on two tabs located at top of cover.
2. Remove relay from Fuse/Relay Block.
3. Check condition of relay terminals and Fuse/ Relay Block connector terminals for damage or corrosion. Repair if necessary before installing relay.
4. Check for pin height (pin height should be the same for all terminals within the Fuse/Relay Block connector). Repair if necessary before installing
relay.
INSTALLATION
The starter relay is located in the Fuse/Relay Block. The Fuse/Relay Block is located under, and to the left side of the drivers seat. See Fuse/Relay Block
cover for relay identification and location.
1. Install relay into Fuse/Relay Block.
2. Install cover to side of Fuse/Relay Block (snaps on).