Sprinter 2500 V6-3.0L DSL Turbo (2008)
INSTALLATION
1. Install the trim panel (2).
2. Connect the control panel (5) electrical connector (4).
3. Connect the inside door opener cable (1).
4. Place trim panel (2) down onto the door and over the lock button. Seat the door trim retainers fully.
5. Install the bolts (6, 8, 10).
6. Install the door pocket (13).
7. Install the cover (7).
A-Pillar Trim Panel-Removal
REMOVAL
1. Using a trim stick C-4755 or equivalent, separate the top of the a-pillar trim.
2. Pull top of a-pillar trim out and pull trim up and remove.
3. Remove the screw and separate the tether from the A-pillar.
A-Pillar Trim Panel-Installation
INSTALLATION
1. Connect the tether to the A-pillar and install the screw.
2. Install the a-pillar trim bottom and push the top in toward a-pillar.
3. Seat the retaining clips fully.
Removal