Sprinter 2500 V6-3.0L DSL Turbo (2008)
Center Support: Service and Repair
Removal
REMOVAL
1. Remove propeller shaft.
2. Mark (1, 3) shafts for installation alignment.
3. Loosen both collar clamps (2).
4. Pull apart propeller shaft (3).
5. Remove snap-ring (1).
NOTE: If center bearing is equipped with a round flange remove bolt from the middle of the flange.
6. Pull off center bearing (4) with a Bearing Splitter 1130 (3) and Bridge 938, (1) with a plug (2) on the end of the shaft.