Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
1. Clean all mating surfaces.
NOTE: Care must be taken not to get any engine sealer on the camshaft journals.
2. Apply a 1.5 mm bead of Mopar(R) Engine RTV Sealant (1) to the cylinder head cover.
3. Place the camshaft seal into position.
4. Install the cylinder head cover. Tighten the bolts in three stages following the sequence provided. First to 4 Nm (35 in. lbs.), then to 6 Nm (53 in.
lbs.), and then to 8.4 Nm (75 in. lbs.).
5. Install the oil separator housing adaptor (2) with new camshaft seal. Tighten fasteners to 9 Nm (7 ft. lbs.).
6. Install the oil separator (1). Tighten fasteners to 9 Nm (7 ft. lbs.).
7. Secure the transmission tube fastener to the engine cover bracket.