Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
14.
Remove the side window airbag assembly from the vehicle.
15.
Position the new side window airbag assembly into the vehicle.
16.
Loosely install the side window airbag fastener on the "B" pillar (Figure 3).
17.
Loosely install the side window airbag fastener on the "A" pillar (Figure 3).
18.
Loosely install the two airbag inflator mounting bolts (Figure 3).
CAUTION:
Be sure to connect the ground wire eyelet to the lower airbag
inflator bolt (Figure 3).
19.
Tighten all of the side window airbag fasteners to 35 in. lbs. (4 N.m).
20.
Remove the orange protective cap from the new airbag electrical connector and connect the body wiring connector to the window airbag squib
connection (Figure 2).
21.
Install the "A" pillar trim panel.
22.
Place the "B" pillar trim panel into position.
23.
Install the grab handle (if equipped).
24.
Install the coat hook onto the "B" pillar.
25.
Install the tie-down ring near the bottom of the "B" pillar.
26.
Install the door opening weather strip.
27.
Repeat Steps 4 through 26 if the opposite side window airbag requires replacement.
28.
Connect the negative battery cable connector located under the instrument panel (Figure 1).