Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Headlamp Alignment Switch: Service and Repair
Installation
INSTALLATION
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
1. Position the headlamp leveling switch (3) to the mounting hole from the face of the left outboard air outlet bezel (4).
2. Using hand pressure, push the switch firmly and evenly into the mounting hole of the air outlet bezel until both of the latch features on the switch
housing are fully engaged.
3. Reinstall the air outlet bezel onto the instrument panel.
4. Reconnect the battery negative cable.