Sprinter 2500 V6-3.0L DSL Turbo VIN 45 (2007)
Windshield Washer Reservoir: Service and Repair
Installation
INSTALLATION
1. Position the washer reservoir (2) into the engine compartment.
2. Engage the standard front and optional rear washer supply hoses into the integral routing guides of the washer reservoir.
3. Lift the washer reservoir upward far enough to access and install the standard front and optional rear washer pump/motor units onto the inboard
side of the reservoir.
4. Position the washer reservoir mounting holes to the bracket (1) on the top of the left front fender inner wheel house.
5. Install and tighten the two screws (3) that secures the washer reservoir to the bracket. Tighten the screws securely.
6. If equipped, install the headlamp washer system pump onto the outboard side of the washer reservoir.
7. Install the washer fluid level switch into the washer reservoir.
8. Refill the washer reservoir with the washer fluid drained during removal.
9. Reconnect the battery negative cable.