Sprinter 3500 L5-2.7L DSL Turbo (2004)
Drink Holders: Service and Repair
CUP HOLDER
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIR-BAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, SEAT BELT TENSIONER, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR
SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE
AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY
SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN
ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Remove rubber mat from both cup holders.
Cup Holder
2. Unscrew screws (1) and remove cup holder top section (2).
Cup Holder Bottom
3. Remove vent hose (1).
4. Unscrew bolts (2) and remove cup holder bottom section (3) from cab floor.
INSTALLATION
1. Install bottom section and install the bolts.
2. Install vent hose.
3. Install top section and install the screws.