Sprinter 3500 L5-2.7L DSL Turbo (2004)
1. Position the belt pulley/vibration damper.
2. Install crankshaft center bolt and washer. Tighten bolt in two stages. M8.8 bolt to 200 Nm (148 ft. lbs.) then 90°, M10.9 bolt to 325 Nm (240 ft.
lbs.) then 90°.
3. Remove the retaining lock for the crankshaft/ring gear (Fig. 46).
NOTE: Inspect accessory drive belt for wear. Replace as necessary.
4. Install accessory drive belt.
5. Install the additional A/C compressor drive belt (if equipped).
6. Install the coolant module (if equipped with the additional A/C compressor).
7. Reconnect negative battery cable.
WARNING: USE EXTREME CAUTION WHEN THE ENGINE IS IN OPERATION. DO NOT STAND IN A DIRECT LINE WITH THE
FAN. DO NOT PUT YOUR HANDS NEAR THE PULLEYS, BELTS OR FAN. DO NOT WEAR LOOSE CLOTHING.
8. Start vehicle and inspect for leaks.