Sprinter 3500 L5-2.7L DSL Turbo (2004)
14. Screw in spindle of riveting tool until firm resistance is felt (Fig. 86).
15. Remove riveting tool.
16. Install moving assembly insert #931211 to #93121.
17. Position riveting tool exactly over middle of pin.
18. Tighten riveting tool spindle to end of travel (Fig. 87).
19. Repeat procedure for both riveting pins (Fig. 87).
20. Inspect riveting, rerivet if required (Fig. 88).
21. Install cylinder head cover.
22. Install engine cover.
23. Connect negative battery cable.
24. Start engine and inspect for leaks. Care must be taken to observe the fuel system warning.
