Sprinter 3500 L5-2.7L DSL Turbo (2004)
Courtesy Lamp Bulb: Service and Repair
ENTRY/EXIT LAMP BULB
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the entry/exit lamp unit from its mounting location.
Entry/Exit Lamp Bulb Remove/Install
3. Grasp the lamp housing firmly in one hand, then rotate the bulb holder counterclockwise and pull it straight out from the housing with the other
hand.
INSTALLATION
1. Insert the bulb into the entry/exit lamp bulb holder.
2. Grasp the entry/exit lamp housing firmly in one hand, then insert the bulb holder into the housing and rotate it dock wise to lock it in place with the
other hand.
3. Reinstall the entry/exit lamp unit into its mounting location.
4. Reconnect the battery negative cable.
ENTRY/EXIT LAMP UNIT
REMOVAL
1. Disconnect and isolate the battery negative cable.
Entry/Exit Lamp Unit Remove/Install
2. Insert the tip of a small flat-bladed screwdriver into the notch on one edge of the entry/exit lamp housing to depress the retainer clip and pull that
edge of the lamp away from its mounting location.
3. Pull the entry/exit lamp unit from its mounting location far enough to access and disconnect the vehicle wire harness from the lamp connector
receptacle.
4. Remove the entry/exit lamp unit from its mounting location.
INSTALLATION
1. Position the entry/exit lamp unit to its mounting location.
2. Reconnect the vehicle wire harness connector to the entry/exit lamp connector receptacle.
3. Position the edge of the entry/exit lamp housing opposite from the retainer clip into the mounting hole.
4. Push firmly and evenly on the notched edge of the entry/exit lamp housing until the retainer clip latches into place.