Sprinter 3500 L5-2.7L DSL Turbo (2004)
Decoupler Installation (INA Splined)
3. Determine if end of generator shaft is hex shaped or is splined If hex is used, insert a 10MM deep socket into tool #8823 (VM 1048) If splined,
insert a 5/16" 6-point hex driver, or a 10MM 12-point triple square driver into tool #8823 (VM 1048).
4. Do not use an adjustable, ratcheting "click type" torque wrench. Most "click type" wrenches will only allow torque to be applied in a clockwise
rotation. Use a dial-type or beam-type wrench. Tighten in counter-clockwise rotation. Refer to torque specifications.
5. Install accessory drive belt, and generator. Refer to Generator Installation.
Litens Decoupler Removal
1. Disconnect negative battery cable.
#8435 Tool And Litens Decoupler