Sprinter 3500 L5-2.7L DSL Turbo (2004)
8. Remove tapered roller bearing, sealing ring, dust shield and bearing cap from axle shaft (Fig. 12).
9. Drive shaft seal out of bearing cover with a hammer and drift.
INSTALLATION
1. Clean sealing surface of bearing cap.
2. Drive axle shaft seal into bearing cover using Installer 9278 (Fig. 13).
NOTE: Install flush to a max. 3 mm (0.12 inch) deep inside the bearing cover.
3. Check roller bearing, replace according to condition.
NOTE: Thoroughly grease roller bearings prior to installation.
4. Install bearing cover with axle shaft seal, new gasket and dust shield on the axle shaft.