Sprinter 3500 L5-2.7L DSL Turbo (2004)
3. Cut the tie wrap on the control module.
4. Unlock and disconnect the wire harness connector from the module connector receptacle.
5. Remove the two screws and nuts that secure the module to the bracket.
6. Remove the module from the bracket.
INSTALLATION
1. Position the rain sensor control module to the bracket under the instrument panel above the throttle pedal.
2. Install and tighten the two screws and nuts that secure the module to the bracket.
3. Reconnect and lock the wire harness connector to the module connector receptacle.
4. Install a new tie wrap to secure the wire harness to the control module.
5. Reconnect the battery negative cable.