SRT-4 L4-2.4L Turbo VIN S (2004)
Front Door Panel: Procedures
REMOVAL
1. Release door latch and open door.
2. Lower door glass.
3. Remove window regulator crank, if so equipped.
Front Door Trim
4. Remove screw from inside arm rest pull cup .
5. Remove screw from behind inside latch release handle.
6. Disengage push-in fasteners attaching trim to door panel around perimeter of trim panel.
7. Tilt trim panel outward to clear locator pins on backside of trim panel.
8. Disconnect trim panel from retainer channel in inner belt weatherstrip at top of door by lifting while gently jiggling.
9. Move trim panel away from door and disengage clip attaching latch rod to handle.
10. Remove latch rod from handle.
CAUTION: Do not allow door trim panel to hang by the wire connector or wiring.
11. Disconnect wire connector from power door lock switch, mirror switch, and power window switch if so equipped.
12. Remove trim panel from door.
INSTALLATION
1. Replace any damaged or missing push in fasteners from around perimeter of door trim panel.
2. Place trim panel near door.
3. Connect wire connector into power door lock switch, mirror switch, and power window switch, if so equipped.
4. Insert latch rod into handle and engage clip.
5. Install trim panel into retainer channel at top of door and push down to seat.
6. Locate door trim panel to inner door panel by aligning locating pins on backside of trim panel to mating holes in inner door panel.
7. Install push in fasteners to hold trim to door panel around perimeter of trim panel.
8. Install screw inside latch release handle.
9. Install screw inside arm rest pull cup.
10. With the window in the down position, orientate the window regulator crank handle appropriately. Install the right handle at the 10 O'clock
position and the left handle at the 2 O'clock position, if so equipped.
