SRT-4 L4-2.4L Turbo VIN S (2004)
Front Door Window Motor: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Move the window to the full-up position, if possible.
3. Remove front door trim panel.
4. Remove front door water shield.
5. Remove three screws to front door radio speaker so that motor has room to pivot.
6. Pivot window motor out of door panel.
7. Remove three motor retaining screws to drive cable.
8. Remove motor from drive cable assembly.
INSTALLATION
1. Install motor to the cable drive assembly.
2. Install motor retaining screws to drive cable.
3. Install the screws to the front door radio speaker.
4. Install the front door water shield.
5. Install the front door trim panel.
6. Reconnect the battery negative cable.
