SRT-4 L4-2.4L Turbo VIN S (2004)
Power Mirror Switch: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Using a trim stick (special tool #C-4755) or equivalent, gently pry up on window switch bezel and remove from door trim panel.
3. Disconnect wire connector from switch.
4. Remove two switch retaining screws.
INSTALLATION
1. Install the retaining screws.
2. Reconnect the wire connector to the switch.
3. Insert switch into door trim panel.
4. Connect the battery negative cable.
