SRT-4 L4-2.4L Turbo VIN S (2004)
Wheel Speed Sensor: Service and Repair
Front
REMOVAL
NOTE: Before proceeding with this procedure, Refer to WARNING.
1. Raise the vehicle.
2. Disconnect the wheel speed sensor cable connector from the wiring harness on the inside of the frame rail above the front suspension crossmember
(Fig. 4). The connector has a locking tab which that must be pulled back before the connector release tang can be depressed, releasing the
connection.
3. If the sensor being removed is a left front, unclip the speed sensor cable from the brake tube on the inside of and under the frame rail (Fig. 5).
4. Remove the speed sensor cable grommet from the retaining bracket attached to the brake hose on the outside of the frame rail.