SRT-4 L4-2.4L Turbo VIN S (2004)
6. Remove the two upper nuts fastening the brake pedal bracket to the power brake booster (Fig. 100).
7. Carefully pry the tie bar running between the two upper booster mounting studs from its plastic retaining fasteners.
8. Remove the two remaining nuts fastening the brake pedal bracket to the power brake booster (Fig. 100).
9. If the vehicle is equipped with antilock brakes, carefully push the power brake booster forward until the booster contacts the ABS ICU mounting
bracket.
10. If the vehicle does not have antilock brakes, carefully push the power brake booster forward one to two inches being careful not to stretch the
brake lines from the master cylinder to the brakes.
11. Remove the two nuts fastening the brake pedal bracket to the instrument panel support (Fig. 100).
12. Carefully remove the brake pedal assembly by pulling the pedal bracket back toward the instrument panel, releasing the bracket from the booster
studs. Next, tip the bracket down past the input rod, guiding the rod through the gap left by the missing brace removed in Step (8). Remove the
brake pedal assembly out from under the instrument panel.
13. The pedal can be removed from its bracket by grinding off the peened end of the shaft, removing the shaft, pedal and bushings. A service parts
package is available to replace these items.
WITH MANUAL TRANSAXLE
1. Remove the instrument panel.
2. Remove the brake lamp switch.
3. Disconnect the clutch cable from the clutch pedal spacer (Fig. 101).
