SRT-4 L4-2.4L Turbo VIN S (2004)
Brake Pad: Service and Repair
Rear
BRAKE PADS/SHOES - REAR DISC
REMOVAL
NOTE: Before proceeding, Refer to WARNING.
1. Raise the vehicle.
2. Remove both rear tire and wheel assemblies from vehicle.
NOTE: Perform Step 3 through Step 7 on each side of vehicle to complete shoe set removal. In some cases, it may be necessary to retract the
caliper piston in its bore a small amount in order to provide sufficient clearance between the shoes and the rotor to easily remove the caliper from
the knuckle. This can usually be accomplished before the guide pin bolts are removed, by grasping the rear of the caliper and pulling outward
working with the guide pins, thus retracting the piston. Never push on the piston directly as it may get damaged.
3. Remove the two caliper guide pin bolts (Fig. 28).
4. Remove the caliper assembly from the brake adapter by first rotating the top of the caliper away from the rotor, and then lifting the caliper
assembly off the machined abutment on the adapter (Fig. 29).