SRT-4 L4-2.4L Turbo VIN S (2004)
Parking Brake Cable: Service and Repair
Installation
INSTALLATION
NOTE: Before proceeding with this procedure, Refer to WARNING. The procedure below applies to either of the two rear parking brake cables.
1. From underneath push the parking brake cable through the hole in the floor pan of the vehicle making sure the cable sealing grommet is installed
in the floor pan as far as possible to insure a good seal.
2. Attach the parking brake cable routing bracket to the tension strut mounting bolts. Install and tighten the mounting nuts to a torque of 28 Nm (250
inch lbs.).
3. Install the parking brake cable into the brake support plate or the rear disc brake adapter. Be sure the locking fingers on the cable retainer are
expanded once the cable is pushed all the way into the support plate or brake adapter hole to ensure the cable is securely held in place.
4. On vehicles equipped with rear drum brakes:
^
Install the parking brake cable on the parking brake cable actuating lever (Fig. 144).
^
Install the actuating spring to the brake shoe and the brake adjustment lever (Fig. 145).
5. On vehicles equipped with rear disc brakes:
