SRT-4 L4-2.4L Turbo VIN S (2004)
Switch Removal
8. Remove switch.
INSTALLATION
The speed control switch is mounted in the steering wheel and wired through the clock spring device under the airbag module.
1. Connect the electrical connector.
2. Install switch and tighten the screws to 1.6 Nm (15 ins. lbs.). Make sure rubber seal is in place around switch.
3. Install airbag, refer to the Restraint Systems section.
4. Install the negative battery cable.
5. Install the air cleaner lid, connect the inlet air temperature sensor and makeup air hose.
