SRT-4 L4-2.4L Turbo VIN S (2004)
Piston: Procedures
STANDARD PROCEDURE - PISTON TO CYLINDER BORE FITTING
NOTE: Pistons and cylinder bores should be measured at normal room temperature, 21°C (70°F).
Piston and cylinder wall must be clean and dry. Piston diameter should be measured 90 degrees to piston pin.
^
Measurement should be taken approximately 22 mm (0.866 inch) from the bottom of the skirt as shown in (Fig. 70).
Cylinder bores should be measured halfway down the cylinder bore and transverse (measurement location B) to the engine crankshaft center line
shown in (Fig. 71). Refer to for Engine Specifications. Correct piston to bore clearance must be established in order to assure quiet and economical
operation.