SRT-4 L4-2.4L Turbo VIN S (2004)
1. Install crankshaft sprocket using Special Tool 6792 (Fig. 136).
2. Install timing belt.
3. Install upper and lower front timing belt covers.
INSTALLATION - CAMSHAFT SPROCKET(S)
CAUTION: Do not use an impact wrench to tighten camshaft sprocket bolts. Damage to the camshaft to-sprocket locating dowel pin may occur.
1. Install camshaft sprockets. Hold sprockets with Special Tool 6847 while tightening center bolt to 115 Nm (85 ft. lbs.) (Fig. 134).
2. Install timing belt.
3. Install upper and lower front timing belt covers.
INSTALLATION - TIMING BELT
1. Set crankshaft sprocket to TDC by aligning the sprocket with the arrow on the oil pump housing.
2. Set camshafts timing marks so that the exhaust camshaft sprocket is a 1/2 notch below the intake camshaft sprocket (Fig. 137).
CAUTION: Ensure that the arrows on both camshaft sprockets are facing up.