SRT-4 L4-2.4L Turbo VIN S (2004)
1. Disconnect negative battery cable.
2. Raise vehicle on hoist. Remove right front wheel.
3. Remove the accessory drive belt splash shield.
4. Remove accessory drive belts.
5. Remove crankshaft damper.
6. Remove the lower torque strut.
7. Disconnect exhaust system from manifold.
8. Disconnect A/C pressure switch at rear of compressor housing.
9. Lower vehicle and support engine with a jack.
10. Remove upper torque strut attaching bolts and remove strut (Fig. 126).
11. Remove power steering pump and bracket. Set pump aside. Do not disconnect lines from pump.
12. With engine properly supported, remove right engine mount through bolt.
13. Raise engine with jack until engine support bracket bolts are accessible (Fig. 128).
14. Remove engine support bracket (Fig. 128).
15. Remove timing belt cover fasteners and remove cover (Fig. 127).
REAR COVER
1. Remove front timing belt covers.
2. Remove timing belt.
