SRT-4 L4-2.4L Turbo VIN S (2004)
Air Duct: Procedures
Left Demister Adapter Duct
REMOVAL
1. Remove the instrument panel assembly from the vehicle and place it on a bench. Refer to: Body and Frame, Interior Trim,
Dashboard/Instrument Panel, Service and Repair, Instrument Panel Assembly Replacement, See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair/Instrument Panel Assembly
2. Remove the air outlet distribution duct from the instrument panel.
3. Remove the screws that secure the left demister adapter duct to the instrument panel.
4. Remove the left demister adapter duct from the instrument panel.
INSTALLATION
1. Position the left demister adapter duct to the instrument panel.
2. Install the screws that secure the left demister adapter duct to the instrument panel. Tighten the screws to 2.3 Nm (20 in. lbs.).
3. Install the air outlet distribution duct to the instrument panel.
4. Install the instrument panel assembly. Refer to: Body and Frame, Interior Trim, Dashboard/Instrument Panel, Service and Repair,
Instrument Panel Assembly Replacement, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Assembly
Air Outlet Center Duct
REMOVAL
1. Remove the center bezel from the instrument panel. Refer to: Body and Frame, Interior Trim, Dashboard/Instrument Panel, Service and
Repair, Instrument Panel Center Bezel, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Center Bezel
Air Outlet Center Duct
2. Remove the screws that secure the air outlet center duct to the center instrument panel.
3. Disengage the air outlet center duct from the air outlet distribution duct.
4. Remove the air outlet center duct from the center instrument panel.
INSTALLATION
1. Position the air outlet center duct to the center instrument panel.
2. Engage the air outlet center duct to the air outlet distribution duct.
3. Install the screws that secure the air outlet center duct to the center instrument panel. Tighten the screws to 2.3 Nm (20 in. lbs.).
4. Install the center bezel onto the instrument panel. Refer to: Body and Frame, Interior Trim, Dashboard/Instrument Panel, Service and
Repair, Instrument Panel Center Bezel, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and
Repair/Instrument Panel Center Bezel
