SRT-4 L4-2.4L Turbo VIN S (2004)
Malfunction Indicator Lamp: Description and Operation
Refer to the Instrument Cluster for more information.
The PCM supplies the malfunction indicator (check engine) lamp on/off signal to the instrument panel through the PCI Bus. The PCI Bus is a
communications port. Various modules use the PCI Bus to exchange information.
The Malfunction Indicator Lamp (MIL) stays on continuously, when the PCM has entered a Limp-In mode or identified a failed emission component.
During Limp-in Mode, the PCM attempts to keep the system operational. The MIL signals the need for immediate service. In limp-in mode, the PCM
compensates for the failure of certain components that send incorrect signals. The PCM substitutes for the incorrect signals with inputs from other
sensors.
If the PCM detects active engine misfire severe enough to cause catalyst damage, it flashes the MIL. At the same time the PCM also sets a Diagnostic
Trouble Code (DTC).
For signals that can trigger the MIL (Check Engine Lamp) refer to the On-Board Diagnostics section.
