SRT-4 L4-2.4L Turbo VIN S (2004)
9. Remove clamp securing fluid return hose to pump reservoir (Fig. 8), then remove hose from reservoir fitting. Cap off hose end and reservoir
fitting.
10. Back out tube nut securing fluid pressure hose to power steering pump and remove hose from pump (Fig. 8). Cap off hose end and pump pressure
port.
11. Remove two remaining (lower) mounting bolts securing power steering pump in place (Fig. 9).
12. Remove lower bolt and loosen (do not remove) upper bolt securing stamped steel support bracket to engine block (Fig. 10).
13. Remove power steering pump with pulley and reservoir attached.
INSTALLATION
1. Using a lint free towel, wipe clean open power steering pressure hose end and power steering pump pressure port. Replace any used O-rings with
new. Lubricate O-ring with clean power steering fluid.
2. Install power steering pump with pulley and reservoir into its mounting area in same fashion it was removed.
3. Place pump in mounting position with stamped steel support bracket behind it. Hand start all three pump mounting bolts through bracket and
pump, and thread into engine cover (Fig. 9). DO NOT TIGHTEN BOLTS AT THIS TIME.
4. Install removed bolt fastening support bracket to engine block (Fig. 10). Tighten both bolts to 54 Nm (40 ft. lbs.) torque.
5. Tighten two lower pump mounting bolts (Fig. 9) to 28 Nm (250 inch lbs.) torque.
6. Thread pressure hose tube nut into pump pressure fitting (Fig. 8). Tighten tube nut to 34 Nm (25 ft. lbs.) torque.
7. Install fluid return hose onto power steering fluid reservoir return fitting (Fig. 8). Expand hose clamp and slide it over hose and pump return
fitting. Secure clamp once it is past bead formed into fluid reservoir fitting.
8. Install bolt securing fluid pressure hose routing clamp to engine (Fig. 7).
9. Raise vehicle.