SRT-4 L4-2.4L Turbo VIN S (2004)
4. Release the locking tab on the wiring harness connector for the power steering fluid pressure switch before connector removal. Remove the wiring
harness connector from the power steering fluid pressure switch (Fig. 28).
5. Remove the drive-belt splash shield fasteners. Remove the shield.
6. Remove the pencil strut from the right front corner of the crossmember and body of the vehicle (Fig. 29). Remove the washer behind the strut from
the torque strut bolt.
7. Remove the bolts mounting the engine torque strut in place (Fig. 29), then remove the engine torque strut from the vehicle.
NOTE: Before removing the front suspension crossmember from the vehicle, the location of the crossmember must be scribed on the body of the
vehicle (Fig. 9). Do this so that the crossmember can be relocated upon reinstallation against the body of vehicle in the same location as before
removal. If the front suspension crossmember is not reinstalled in exactly the same location as before removal, the preset front wheel alignment
settings (caster and camber) will be lost.
