Stratus L4-2.0L VIN C (1997)
Vacuum Brake Booster: Service and Repair
Installation
PROCEDURE
1. Position power brake booster onto dash panel.
Power Brake Booster Mounting
2. Install and torque the 4 power brake vacuum booster mounting nuts to 29 Nm (250 in. lbs.) torque.
3. Using Lubriplate, or an equivalent, coat the surfaces of the brake pedal pin that contact the power brake vacuum booster input rod.
4. Connect power brake vacuum booster input rod to brake pedal pin and install a NEW retaining clip.Use only a new retainer clip DO NOT USE the
old clip.
5. Position master cylinder on studs of power brake unit, aligning push rod on power brake vacuum booster with master cylinder push rod.
Master Cylinder Mounting To Vacuum Booster
6. Install the 2 master cylinder to power brake unit mounting nuts. Tighten the 2 mounting nuts to a torque of 28 Nm.m (250 in. lbs.).
7. Install the vehicle's wiring harness connector on the master cylinder brake fluid level sensor.
