Stratus L4-2.4L DOHC (1995)
2.
Raise vehicle on a suitable frame hoist so the tires are just off the ground.
3.
Loosen the four shock absorber mounting bolts on the side you marked in step # 1.
4.
Remove the plastic locating pins from the shock bracket using a punch or pliers.
NOTE:
DO NOT LEAVE THE PLASTIC PINS IN THE CAVITY OF THE SHOCK TOWER, OBJECTIONABLE NOISE MAY RESULT.
5.
Position the shock assembly inboard/outboard as required to adjust the camber. Make sure the fore/aft position is the same as indicated by the
marks made prior to adjustment and the forward and rearward bolts have moved inboard or outboard equal amounts.
6.
Torque shock absorber mounting bolts to 90 Nm (68 ft.lbs.).
7.
Check front end alignment and set toe if required.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
02-00-01-90
Camber, Front Suspension Adjust
1.1 Hrs.
FAILURE CODE: XX - Service Adjustment
Technical Service Bulletin # 021295
Date: 951027
Alignment - Vehicle Drift/Lead At Highway Speeds
NO: 02-12-95
GROUP: Front Suspension
DATE: Oct. 27, 1995
SUBJECT:
Vehicle Drift/Lead
At Highway Speeds
MODELS:
1995 - 1996 (JA) Cirrus/Stratus
SYMPTOM/CONDITION:
Vehicle may drift or lead left or right at highway speeds during straight ahead driving. May be more pronounced on crowned roads.
DIAGNOSIS:
Verify vehicle lead or drift, cross switch front tires, and check front cross camber. If vehicle still drifts/leads and front cross camber is excessive, perform
repair procedure.
NOTE:
CROSS CAMBER IS THE LEFT CAMBER READING MINUS THE RIGHT CAMBER READING.
REPAIR PROCEDURE:
This bulletin involves adjusting the front suspension camber.
