Stratus V6-2.5L VIN H (1997)
Fig. 7
9. If vehicle is equipped with antilock brakes, install the wheel speed sensor cable routing clip on upper control arm mounting bracket. Install and
securely tighten attaching bolt.
10. Install wheel and tire assembly on vehicle. Tighten the wheel mounting stud nuts in proper sequence until all nuts are torqued to half specification.
Then repeat the tightening sequence to the full specified torque of 129 Nm (95 ft. lbs.).
11. Lower vehicle to the ground.
12. Check and reset if required, rear wheel alignment to meet the preferred specifications.