Stratus V6-2.5L VIN H (1997)
Turn Signal Flasher: Description and Operation
GENERAL INFORMATION
Multi-Function Switch
WARNING: ON VEHICLES EQUIPPED WITH AIRBAG, SEE AIR BAGS AND SEAT BELTS/AIR BAGS
FOR AIRBAG REMOVAL PROCEDURES.
Multi-Function/Exterior Lamp Switch
The multi-function switch contains:
-
Turn signals
-
Hazard warning
-
Headlamps
-
Headlamp beam select
-
Parking lamps
-
Panel dimmer
-
Fog Lamp
-
Headlamp optical horn
-
Windshield wiper
-
Pulse wipe
-
Mist wipe
-
Windshield washer switches.
The multi-function switch is mounted center of the steering column. There are two levers one on each side of the steering column. The left side
controls the signaling and lighting. The right side controls the windshield wiper and washer system. When the driver wishes to signal his intentions
to change direction of travel, he moves the left lever upward to cause the right signals to flash and downward to cause the left signals to flash.
After completion of a turn the system is deactivated automatically. As the steering wheel returns to the straight ahead position the turn signals are
canceled. A canceling cam is molded to the clockspring mechanism which comes in contact with the cancel actuator on the multi-function switch.
The canceling cam lobe pushes on the cancel actuator and returns the switch to the off position.
If only momentary signaling such as indication of a lane change is desired, the switch is actuated to a left or right intermediate detent position. in
this position the signal lamps flash as described above, but the switch returns to the OFF position as soon as the lever is released.
SYSTEM OPERATION
Combination Flasher
The turn signal flasher and the hazard warning flasher are combined into one unit called a combination flasher (combo-flasher). An inoperative or
incomplete turn signal circuit will result in an increase in flasher speed.
The flasher is mounted to the back side of the multi-function switch.
Exterior Lamps
To turn lamps ON:
