Stratus V6-2.5L VIN H (1997)
Alignment: Testing and Inspection
Before any attempt is made to change or correct the wheel alignment factors. The following part inspection and the necessary corrections should be made
to those parts, which influence the steering of the vehicle.
1. Check and inflate all tires to recommended pressure. All tires should be the same size and in good condition and have approximately the same
wear. Note the type of tread wear which will aid in diagnosing.
2. Check front wheel and tire assembly for radial runout.
3. Inspect lower ball joints and all steering linkage for looseness.
4. Check for broken or sagged front and rear springs.
5. Check vehicle ride height to verify it is within specifications.
6. Alignment MUST only be checked after the vehicle has the following areas inspected and or adjusted. Recommended tire pressures, full tank of
fuel, no passenger or luggage compartment load and is on a level floor or a properly calibrated alignment rack.
