Stratus V6-2.5L VIN H (1997)
Power Steering Valve: Service and Repair
Solenoid Control Valve Module Replacement
GENERAL INFORMATION
The solenoid control module is mounted on the steering gear assembly fluid lines using attaching clips on back of module. The solenoid control
module is removable from the steering gear for servicing, without removing steering gear from vehicle.
REMOVE
1. Remove wiring harness connectors from solenoid control module.
2. Unclip locking tab on bottom side of solenoid control module, holding control module to steering gear fluid lines. Then-rotate control module
upward and remove the upper 2 attaching clips from the steering gear fluid lines.
INSTALL
1. Hook upper tabs on solenoid control module onto upper steering gear fluid line. Then rotate module downward until locking tab on bottom of
module is locked on lower power steering gear fluid line.
2. Connect wiring harness connectors onto solenoid control module. Be sure wiring harness connector seals are on connectors and in good condition
before installing connectors on control module.
